Dometic COOLAIR SPX1200I, Руководство по установке

Страница: 13 / 222

11
EN
CoolAir SPX1200I Installation
6.5 Sealing and attaching the hood
A
I
➤
Mount one clip (fig.
9
).
➤
Mount the hood (fig.
9
).
6.6 Routing supply lines to condenser unit
I
➤
Shorten any supply line which is not needed by bending a curve.
➤
Fasten the supply lines to the cab's rear panel using the clips (fig.
0
).
6.7 Connecting condenser unit to evaporator unit
➤
Route the connection cable in a curve out through the opening in the floor of
the condenser unit.
➤
Fasten the connection cable as shown (fig.
a
and fig.
b
).
NOTICE!
When bending the supply line make sure that the radius is not too narrow. Use
a suitable round object with a shim as a bending aid.
A radius which is too narrow will kink the refrigerant line, and this will prevent
the parking cooler from operating.
NOTE
If you wish to avoid damaging the cab's rear panel (drilling a hole), you can also
fix the hood in place using a suitable adhesive. Observe the instructions
provided by the adhesive manufacturer.
NOTE
• The installation manual for the SPX1200C condenser unit should also be
observed.
• Mount the SPX1200C condenser unit first to enable the exact position of
the condenser unit to be determined. This will save you bending the cop-
per pipe several times to make it fit.
• Make sure that the maximum length of the supply lines does not exceed
2.1 m.
• Avoid any narrow radiuses when routing and bending supply lines. Use a
suitable round object with a shim as a bending aid. A radius which is too
narrow will kink the refrigerant line, and this will prevent the parking cooler
from operating.
• If you wish to avoid damaging the cab's rear panel, you can also fix the clip
in place using a suitable adhesive. Observe the instructions provided by the
adhesive manufacturer.
63;,,VERRN6HLWH)UHLWDJ6HSWHPEHU