1. To turn ON the CCC 2 thermostat
when the back light is off,
fi
rst press
any button to wake up the CCC 2
thermostat. Then press and release
the
ON/OFF
button.
2. Press the
MODE
button to cycle
through the mode options.
A mode is
an operation that can be performed
by the unit and is controlled by
the Dometic CCC thermostat.
The
available modes are:
OFF
,
COOL
,
HP
(HEAT PUMP),
HS
(Heat Strip),
FAN
,
FURN
(Furnace), and
AUTO
.
The available modes are determined
by your system options.
3. Press the
ZONE
button to cycle
through the available zones to be
programmed.
Each zone signifi es a
unit designated to cool, heat or de-
humidify a specifi c area of an RV.
The Dometic CCC 2 thermostat can
control up to four units (zones).
4. Press the
UP
or
DOWN
but-
tons to increase or decrease the room
air temperature (hereinafter referred
to as the set-point).
The set-point
is the desired inside room air tem-
perature.
5. Press the
FAN
button to select the
fan speed. The options are
AUTO
,
HI
,
MED
, or
LO
.
7. Press and hold the
INSIDE TEMP
button and the LCD will display the
current inside temperature recorded
at the CCC 2 Thermostat (or at the
optional remote indoor temperature
sensor) instead of the temperature
set-point. The LCD will also display
“IN”
to indicate that the inside tem-
perature is being displayed. When the
INSIDE TEMP
button is released, the
LCD will return to the programmed
temperature set-point.
6. Press the
CLOCK
button to initiate
the clock setting sub-menu on the
CCC 2 thermostat. When entering
this menu, the
“hour”
digits will
fl
ash
fi
rst. Press the
CLOCK
button again
and the
“minutes”
digits will
fl
ash.
Press it a third time and the
“AM”
or
“PM”
icon will
fl
ash.
Press the
UP
and
DOWN
but-
tons to set the
“hour”
,
“minute”
, and
“AM/PM”
setting.
Press the
CLOCK
button one more
time to store the new time in memory
and exit the clock setting sub-menu.
