EN
Operation
CoolFreeze
14
CDF26: Setting the battery monitor mode
This is how to select the battery monitor mode:
➤
Switch on the cooler.
➤
Press the “SET” button three times.
➤
Use the “+” and “–” buttons to select the battery monitor mode.
✓
The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
CDF36, CDF46: Setting the battery monitor mode
This is how to select the battery monitor mode:
➤
Switch on the cooler.
➤
Press the “SET” button three times.
➤
Use the “ADJUST” button to select the battery monitor mode.
7.5
Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
➤
Close the cooler, see chapter “Connecting the cooler” on page 12.
A
Locking the cooler
➤
Close the lid.
➤
Press the lock (fig.
6
1, page 3) down, until it latches in place audibly.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CDF18-26-36-46--O-16s.book Seite 14 Montag, 7. November 2016 2:13 14
Autogoods “130”
130.com.ua
