Cabana Lightweight RV Dome Awning™ Installation and Operation Instructions
5
5. Hook opposite end of telescoping pole onto front
flex pole thru opening in fabric assembly. This op
-
eration is easier to do from outside of Dome Aw-
ning or with help from outside of Dome Awning.
6. Extend telescoping pole to stretch roof fab-
ric out and lock Clenchlock Lever in place.
Repeat above step with remaining 2 telescoping
poles.
2. Once Dome Awning is in place, install snap fast
fasteners where side wall flaps meet camper.
This provides a seal between tent room and
camper.
3. Roll flaps w/Velcro around camper extender
arms.
4. Install Wheel Well Skirt over wheel well
by marking grommet points at desired
height and drilling pilot holes then installing
snap fast fasteners.
5. Mark grommet points and drill pilot holes to
install snap fast fasteners for Vehicle Skirt.
Measure and install Vehicle Skirt across entire
vehicle. Cut excess skirt if necessary.
LOCKED POSITION
C. Seal Dome Awning & Install Skirts
1. Straighten out fabric and fold bottom flaps towards
outside.
