12
After the delay, the compressor will start. Usually the fan will stop and will not re
energize until the heat exchanger has warmed and then the fan will start to blow
warm air.
The
DRY
mode is used when the room temperature is close to comfortable but you
wish to dehumidify.
Press
MODE
button to highlight
DRY
.
Set the temperature to desired setpoint.
NB: The fan speed is locked in
LOW.
The compressor will cycle on and off at approximate intervals of 6 minutes to extract
moisture from the air.
SLEEP mode:
If the unit is operating in cooling, then if the
SLEEP
button is pressed
to highlight the Sleep light, then the unit over the next one hour will automatically
raise the set point by 1C.
Conversely in
HEAT
mode, the setpoint will be lowered 1C.
The
TIMER
may be used to turn off the unit in the future (up to 24 hours)
Or
May be used to turn on the unit up to 24 hours into the future.
Press
TIMER
button once and the display will flash. Within 3 seconds ,Press the
timer button until you have set desired time into the future to turn off unit.
A subsequent press of the timer button will allow the time to start the unit to be
programmed.
LOCKING FUNCTION:
This provides a means of locking in the mode and fan speed settings.
To lock. Press
Temp down
key simultaneously with
MODE button.
Hold for 3 seconds and the lock indicator will light.
To unlock, repeat above procedure.
To change readout from Centigrade to Fahrenheit or vice versa:
Press
Temp down
key simultaneously with the
Fan
key.
More information https://www.caravansplus.com.au
