Dometic 9600013958, Инструкция по установке и эксплуатации, Страница: 14 / 164

Installing the video splitter VS 400N
EN
14
To establish and test the electrical connection , the following tools are required:
See fig.
4
, page 5
• Diode test lamp ( 8 ) or voltmeter ( 9 )
• Crimping tool ( 10 )
• Insulating tape ( 11 )
• If applicable, cable bushing sleeves
To secure the control unit and the cables , you may require additional screws and cable ties.
!
Note the following instructions during installation:
• The installation location must be protected from moisture and be inside the vehicle.
• The installation location should be flat.
• Before drilling each hole, ensure there is sufficient space on the other side for the drill head to
emerge (fig.
5
, page 6).
To perform the installation, proceed as follows:
➤
Attach the control unit and the operating unit to their respective installation location provision-
ally.
➤
Install the reversing video system if you have not already done so.
➤
Start up the reversing video system.
If transmission of the camera image is stable, you can carry out the final installation of the con-
trol unit and operating unit.
6.2 Installing the operating unit
I
Proceed as follows:
➤
Glue the Velcro strip to the bottom of the operating unit.
➤
Glue the matching Velcro strip to a suitable position in the vehicle (fig.
6
, page 6).
➤
Affix the operating unit.
CAUTION!
Select the location of the modules so that they cannot injure the passengers in the vehi-
cle under any circumstances (e.g. sudden braking, traffic accidents).
NOTE
Make sure the adhesive surfaces (surface and bottom of the unit) are clean, dry and free
of grease.
VS400N-IO-16s.book Seite 14 Montag, 12. November 2018 3:05 15