8
EN
Pre-Installation
Oasis Elite 975 Series
6.1 Installing the Awning Rail and
Inserting the Awning
q
e
w
7
Installing the Awning
q
Awning Rail
e
Awning Back Rail
Bracket
w
Awning Back Rail
1. Apply sealant to the back edge of the awning rail and
to the #6-20 X 1/2 in. screws (provided).
2. Place and tighten the screws through the awning rail
and into the RV wall.
3. Carefully lift the awning and align the back rail bracket
to the prepared awning rail end. Use a stepladder if
necessary.
4. Insert the back rail bracket into the awning rail.
5. Carefully slide the awning until it is in the desired
position.
To facilitate sliding along the rail, you may rotate the
awning up and secure the motor wiring out of the
way.
6.2 Making the Electrical
Connections
t
w
e
r
8
Awning Wiring Hole Location
q
Wiring Hole
r
Bottom Edge to Wiring
Hole: 3.6 in. (9.1 cm)
w
Left-Hand (LH) Cover
e
Awning Back Rail
t
LH Cover to Wiring
Hole: 0.7 in. (1.8 cm)
1. Mark the awning wiring hole location. With the
awning in the desired position:
a. Make a vertical mark along the LH edge of the
awning back rail.
b. Make a horizontal mark along the bottom edge of
the awning back rail.
c. Carefully slide the awning along the awning rail to
the right, far enough for free access to the marked
location.
d. Measure 3.6 in. (9.1 cm) above the horizontal
mark, and make a new horizontal mark.
e. Measure 0.7 in. (1.8 cm) to the left of the vertical
mark, and make a new vertical mark that crosses
the second horizontal mark.
