8
Service
Dometic 4410N Commode
2. Adjustment of Flush Mechanism Cam Switch
Familiarization with components is recommended before servicing the 4410N
commode, using exploded view on page 11 .
The flush ball should be properly
positioned so that the “A” and “B”
distances are equal (see illustration
at right) . If the flush ball becomes
misaligned (resulting in water leaking
from bowl or other flushing problems),
follow instructions below to resolve
problem .
REMOVING COMMODE FROM
FLOOR
1 . Follow
Service
instructions on
page 6,
steps a, b, c, e, f, h,
to remove commode from floor
and turn it upside down .
2 . MAKE SURE POWER WIRES
REMAIN SECURE TO
COMMODE .
TO CORRECT PROBLEM 3b:
3 . Loosen cam switch mounting
screws with 3/32-inch hex tool
and 1/4-inch box-end wrench .
Slide cam switch up or down
(see illustrations below) depend-
ing on flush ball position .
5 . Tighten cam switch mounting
screws, apply electrical power
and check adjustment . Repeat
as necessary .
6 . After cam switch and flush ball
are properly positioned, reinstall
commode .
Over-travel condition
Slide
cam
switch
DOWN
Slide
cam
switch
UP
Under-travel condition
