Dometic 309311001, Инструкция по установке и эксплуатации

Страница: 6 / 19

EN
Inserting the filter DVF
6
4.2 Inserting the filter
➤
Remove the red stoppers from both connectors of the vent filter.
➤
Select a suitable adapter:
➤
Grease the O-ring on each connector of the vent filter using a liquid soap or sili-
cone grease.
➤
Be sure to push hose adapters completely over o-rings before threading the
retaining fastener to the filter.
➤
Screw the selected adapter together with the hose couplings (fig.
2
3, page 2)
on the vent filter.
➤
Insert the vent filter into the holder so that it latches into place.
For using thread adaptors only
➤
Check that there are seals (not included in delivery) in the connectors of the
hoses.
➤
Connect the vent hose from the tank (fig.
4
3, page 3) and the vent hose to the
hull vent pipes (fig.
4
1, page 3) with the vent filter (fig.
4
2, page 3).
➤
Tighten the connectors by hand.
➤
Tighten the connectors further by a 1/4 to 1/2 a turn using a tool.
For using threadless hose adaptors only
➤
Connect the vent hose from the tank (fig.
5
4, page 3) and the vent hose to the
hull vent pipes (fig.
5
1, page 3) with the vent filter (fig.
5
3, page 3).
➤
Secure the vent hoses on the adapters with hose clips (fig.
5
2, page 3).
No. in
fig.
3
,
page 2
Description
5a Adapter for thread with 3/4" or 19mm ID hose
5b Adapter for hose with 5/8" (16mm) – 3/4" (19mm) ID hose
5c Adapter for hose with 1" (25mm) – 1-1/2" (38mm) ID hose