Domaplasma IQS650, Руководство пользователя, Страница: 28 / 52

28
3.2 Installation instructions
6. Ensure that the outlet manifold of the cooker hood or downdraft has a direct or indirect
cross-section of 220 x 90 mm (preferably type NABER).
7. Ensure that the space around the three black air outlets is at least 25 mm wider than
the Domaplasma ® filter. The inside height of the plinth has to be at least 100 mm. The
backside of the Domaplasma
®
filter is meant to be attached directly to the wall, the
ceiling or the surface, as no air is vented here. The upper side should be installed so that
it remains accessible for service operations.
8. The plinths must be equipped with sufficient air vents preferably > 600 cm
2
(800 cm
2
for type 850) of free outlet openings, so that the air can recirculate freely.
9. Place the Domaplasma ® filter directly or indirectly on the outlet manifold of the cooker
hood or downdraft.
The Domaplasma ® filter is now properly installed on or to the cooker hood.
10.
Take the supplied power cable and connect it to the C14 connection of the
Domaplasma
®
filter. Connect both the plug of the Domaplasma
®
filter and the plug of
the cooker hood to the power connection(s).
3.2 Electrical connection
Check before plugging into the electrical connection whether the data on the type plate and
the local power supply correspond.
The type plate is placed next to the C14 power connection of the Domaplasma ® filter.
The Domaplasma ® filter is always provided with a C13 cable and a grounded plug. These
can be connected to any secured and grounded power point of 220 - 240 Volt, 50 Hz.
The power connection should preferably be positioned near the cooker hood so that it might
not directly accessible/visible.
Because in this way the power connection might no longer be accessible after the
installation, it is necessary to be able to switch off the power circuit to which the cooker
hood and Domaplasma ® filter are connected, before maintenance.