MXP909 PXIe module
User’s Guide –
Dolphin Interconnect Solutions
Page 10
Operation
Configuration and DIP Switches
The MXP909 module has two banks of 8 DIP switches. The default factory setting for the MXP909 module is Transparent Host
mode, single (up to x8) link connection.
The MXP909 module has DIP switches for setting special modes or operations, the meaning of each DIP switch depends on the
loaded firmware. Please carefully read the documentation shipped with the module before modifying any DIP switch settings.
Please pay close attention to ON and OFF positions written on the DIP switch.
DIP Switches
Please leave all undocumented DIP switches in the default position. Table 3: DIP SW1 settings and Table 4: DIP-SW2 settings below
shows all the various DIP switch settings for the MXP909 module.
Note: DIP switch configuration
options may be changed in the future versions. Please always consult the latest user guide
for details. The table above is valid for version 1.5.
DIP-Switch SW1 settings
SW1 DIP
no.
Description
ON
OFF
Default
1-8
Configuration selector, details
below
OFF
Table 3: DIP SW1 settings
DIP-Switch SW2 settings
SW2 DIP
no.
Description
ON
OFF
Default
1
Reserved, leave in Default OFF
OFF
2
Enable Wake
Enable PCIe WAKE
PCIe Wake Disabled
OFF
3
Reserved, leave in Default OFF
OFF
4
Disable thermal shutdown
Thermal shutdown
disabled
Shut down the switch if
critical temperature
reached.
OFF
5-8
Reserved, leave in Default OFF
OFF
Table 4: DIP-SW2 settings
