11
13
3
F
Line up the hole in the sprocket guard with the threaded pin
(
11
).
Turn the chain tensioning screw (
H
/
14
) to align the chain ten-
sioning pin (
12
) with the hole in the guide bar.
Using your left hand, lightly press the guide bar against the
holder on the housing and guide the saw chain (
9
) around the
nose sprocket (
10
) on the guide bar. While doing this, pull the
saw chain slightly in the direction shown by the arrow.
E
H
Tightening the saw chain
Firmly push in and simultaneously turn the sprocket guard
quick tightener (
2
, clockwise) in order to screw on the sprocket
guard (
3
), but do not tighten it yet.
Lift the tip of the guide bar slightly and turn the chain tensioner
(
14
) clockwise until the saw chain engages in the guide groove
on the lower side of the guide bar (see the circle).
Push in the sprocket guard quick tightener (
2
) again and tight-
en by turning clockwise.
Release the sprocket guard quick tightener (
2
) (remove pres-
sure) until it turns freely, then fold it in as shown in the illustra-
tion.
9
10
14
2
2
11
3
12
G
First press the sprocket guard (
3
) into the mounting (
13
) and
then push it onto the threaded pin (
11
).