Original Operating Instructions
Staxo/d2 winch
5
999280002 - 02/2018
Travelling the towerframe units
Safety requirements
▪
4 winches must be fixed to each towerframe unit that
is to be travelled.
▪
After clamping the winches onto the frames, push
the base units up into the towerframe unit and secure
them.
Max. distance from floor: 50
mm.
▪
Max. travel speed: 2
km/h.
▪
The floor must be stable, firm and sufficiently smooth
(e.g. concrete).
▪
Max. permitted inclination of trackway: 2%
The permissible inclination of the trackway must be
determined by statical calculation (risk of overturn-
ing, rolling forces).
▪
Either bridge any openings in the floor with suffi-
ciently strong planking/boards secured so that they
cannot slip away to either side, or close off openings
with sufficiently strong side railings!
▪
Special care is needed when travelling across shoul-
ders in the ground (no sharp-edged shoulders, max.
shoulder-height 15
mm).
▪
Keep the travel route clean and free of any obsta-
cles.
▪
It is forbidden to use any mechanical assistance dur-
ing the wheeling operation!
▪
Only travel with pinion-rack retracted as far as possi-
ble!
▪
After the towerframe unit has been travelled, or for
longer breaks during the travelling operation,
remove the load from the winches so that it cannot
be moved accidentally!
▪
It is forbidden for any third persons to linger in the
immediate danger zone!
▪
It is forbidden for persons to ride on towerframe units
while these are being travelled!
▪
It is only permitted to travel Doka load-bearing tow-
ers that have been braced in accordance with the
assembly plans and erection rules given in the User
Information booklet.
▪
Before travelling the tower, remove any loose
objects from the formwork and scaffold (tools, con-
nector components, residual dirt etc.).
Declaration of conformity
NOTICE
With standard superstructures, the max.
width-to-height ratio of the table+tower is 1:3.
A statical check must be performed on custom
constructions.
92800-206-01
NOTICE
▪
Exercise caution regarding the risk of over-
turning (particularly in strong wind).
▪
Take care to start moving gently, and to
exert a constant, uniform pull.
EC Declaration of Conformity
pursuant to EC Directive 2006/42/EC.
The manufacturer declares that by reason of its conception and
design, the following product
Winch 70, Art. n° 582779000
Winch 125, Art. n° 582780000
conforms – in the version marketed by ourselves – to the pertinent
fundamental health and safety stipulations of the relevant EC Direc-
tives.
The following harmonised Standards were applied:
▪
EN ISO 12100:2010
▪
EN 349:1993+A1:2008
Person authorised to compile technical documentation
(pursuant to European Directive on Machinery Annex
II):
Dipl.-Ing. Ludwig Pekarek
Josef Umdasch Platz 1
A-3300 Amstetten
Amstetten, 14.02.2018
Doka GmbH
Josef Umdasch Platz 1
A-3300 Amstetten
Dipl.-Ing. Ludwig Pekarek
Executive Manager
Dipl.-Ing. Peter Reisinger
Authorised Officer, Head of Engi-
neering
