This device is intended only for OEM integrators under the following conditions:
1)
The
antenna
must
be
installed
such
that
20
cm
is
maintained
between
the
antenna
and
users,
and
2)
This
device
and
its
antenna(s)
must
not
be
co
‐
located
with
any
other
transmitters
except
in
accordance
with
FCC
multi
‐
transmitter
product
procedures.
Referring
to
the
multi
‐
transmitter
policy,
multiple
‐
transmitter(s)
and
module(s)
can
be
operated
simultaneously
without
C2PC.
3)
For
all
products
market
in
US,
OEM
has
to
limit
the
operation
channels
in
CH1
to
CH11
for
2.4G
band
by
supplied
firmware
programming
tool.
OEM
shall
not
supply
any
tool
or
info
to
the
end
‐
user
regarding
to
Regulatory
Domain
change.
USERS
MANUAL
OF
THE
END
PRODUCT:
In
the
users
manual
of
the
end
product,
the
end
user
has
to
be
informed
to
keep
at
least
20cm
separation
with
the
antenna
while
this
end
product
is
installed
and
operated.
The
end
user
has
to
be
informed
that
the
FCC
radio
‐
frequency
exposure
guidelines
for
an
uncontrolled
environment
can
be
satisfied.
The
end
user
has
to
also
be
informed
that
any
changes
or
modifications
not
expressly
approved
by
the
manufacturer
could
void
the
user's
authority
to
operate
this
equipment.
If
the
size
of
the
end
product
is
smaller
than
8x10cm,
then
additional
FCC
part
15.19
statement
is
required
to
be
available
in
the
users
manual:
This
device
complies
with
Part
15
of
FCC
rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
this
device
may
not
cause
harmful
interference
and
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.
LABEL
OF
THE
END
PRODUCT:
The
final
end
product
must
be
labeled
in
a
visible
area
with
the
following
"
Contains
FCCID:
2AL3B
‐
ESPF1".
If
the
size
of
the
end
product
is
larger
than
8x10cm,
then
the
following
FCC
part
15.19
statement
has
to
also
be
available
on
the
label:
This
device
complies
with
Part
15of
FCC
rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
this
device
may
not
cause
harmful
interference
and
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.
-OEM integratoris responsible for ensuring that the end-user has no manual
instructions to remove or install module.
-That module is limited to installation in mobile or fixed applications,
according to Part 2.1091(b)
-Separate approval is required for all other operating configurations,
including portable configurations with respect to Part 2.1093 and different
antenna configurations
