7
POWERED BY CIRCUIT FUSE
Firstly
, recommended and connect the RED Wire(ACC+) to the fuse
switch.
Secondly
, find the car circuit fuse box under your car cab.
Finally
, according to the labels on the fuse hardwire to find the
corresponding power fuse
and connect the corresponding line (voltage must between 12-32V).
Note
: If connecting power directly to battery, the camera is always ON and
therefore can drain battery. Therefore it is recommended to connect power
to an ignition switched accessory power source.
INSTALLATION CAMERA
Firstly
, find the best installation position to install backup camera on your
vehicle,e.g. close to rear marker lights, centered on vehicle.
Secondly
, remove the camera U-bracket, mark the hole position with a
marker pen, then drilling, after the hole is finished, route the terminal wire
of the camera through it and install the screw of the backup camera.
Finally
,adjust the best angle.
INSTALLATION MONITOR
Firstly
, Find the best installation position to install monitor in your vehicle.
Secondly
, Remove the screw around then take out the monitor. Put
U-bracket to the right place and adjust angle, prepare 2 screws.
Thirdly
, Locking the bracket by screws. Put the monitor into bracket and
locking it.
Finally
, adjust the best angle to allow optimum driver viewing comfort by
themself.
OPERATION GUIDE
REMOTE CONTROL
Power button
Video select button
Left arrow(Positive/increase) button
Menu button
Right arrow(Negative/decrease) button
Mode select button:rotate flip image/normal/mirror image setting
FUNCTIONS OPERATE
V1/V2 button
: switch CH1 and CH2 channel camera.
Mode button
: rotate flip image/normal/mirror image setting.
Power button
: turn on/off and stadnby.
