A Installing the Wheels:
1. Reinsert or adjust axle on T-Base. Ensure it is
visible from both ends.
2. Slide on the Wheel.
3. Slide on the small Washer.
4. Insert the Cotter Pin through the Axle. Cotter Pin
must be bent outward to lock in place.
5. Slide the Cap in place (see Figure 1)
6. Repeat process for second Wheel.
B Installing the Wheel Handle to the Base:
1. Insert the Elastic Straps into the grooves.
a. Groove for the straps will not align throughout
the Solar Reel (see Figure 2).
b. Each Elastic Strap should be evenly placed on
the Tubing to provide support for the Cover.
2. Slide the large Tube Adapter into the T-Base.
3. Insert the Dowel into the Tube Adapter
Note: The pedal should be at a 90 degree angle
from vertical. This will lock the Tube Adapter in
place when turned downwards (see Figure 3).
4. Slide the Wheel Handle onto the top of the Base.
a. The Wheel Handle needs to be inserted on the
side with the most axle exposed.
b. You will need to line up the screw hole in the
handle with the pre-drilled hole in the Tube
Adapter Axle (you should be able to see through
the handle and axle).
c. If you are having difficulty with Step 4b, you may
need to use a rubber mallet.
5. Insert Screw M5X80 and screw it into the Wheel
Handle, followed by the M5 Closed Nut.
C Installing the Tube Adapter to the Base:
1. On the opposite side of the Wheel Handle, insert
the Tube Adapter to the top of the Base.
2. Slide the Dowel in place into the Tube Adapter.
3. Place the Washer into the Tube Adapter.
4. Insert Screw M5X40 into the Tube Adapter and
screw it into place.
5. Screw M5 Open Nut into the bottom of M5X40 Screw.
6. Slide the Cap into place (may need rubber mallet).
6950 51st Street Kenosha WI 53144 | Orders and Customer Care: 1-800-574-7665 | Fax: 1-800-323-5932 | Doheny.com
Figure 1
Figure 3
Figure 2
