Dogtra e-Fence, Руководство пользователя

Страница: 25 / 31

25
Note : If you alter the field adjustment knob by turning it clockwise or counterclockwise, or
by removing it, you must check the signal field for the desired setting.
When you are satisfied with the field width setting, bury the fence wire below the grass and
place the flags at the distance where the test light comes on.
E-fence Training Tips
To get the most effective results with your Dogtra e-Fence, keep these tips in mind :
y The collar must be on relatively tight. The contact points should maintain contact with
the dog ’ s skin without restricting breathing. You should be able to slide one finger
under the strap at the back of your dog ’ s neck.
y The proper level of stimulation to use is when your dog responds with a mild twitch of
the neck, shoulder, head or ears. If your dog cries out after receiving stimulation, the
level needs to be reduced. The dog should never cry out when the transmitter is set at
the proper stimulation level.
y DO NOT leave the collar receiver on the dog for more than 12 hours a day. Leaving the
collar/receiver on the dog for extended periods of time can cause skin irritation around
the neck or at the site where the contact points make contact with the skin.
y DO NOT use the collar on a dog that is under 6 months of age.
y
Remove other metal collars from your dog when he is wearing the Dogtra e-collar
receiver. Other metal collars may interfere with the stimulation.
y Make sure the collar receiver is working properly before putting it on your dog. Verify
that the Dogtra e-fence system is operating properly and that the field width is
appropriate.
y Use the lowest stimulation level on the wall transmitter to contain the dog. Use higher
stimulation levels only if necessary.
y Place the training flags around the perimeter where the test lamp comes on ten feet
apart. This will teach the dog to learn the boundaries of the e-fence system.
y Keep training sessions short and positive. Do not train the dog after the dog has lost