Dogtra BALL TRAINER PRO, Руководство пользователя, Страница: 9 / 12

15 14
1. Using a screwdriver, remove the
3 screws on the battery cover on the
back of the transmitter.
2. Replace the batteries with two AAA
1.5V alkaline batteries. Check that
the batteries match the polarity
indicated on the battery holder.
3. Place the battery cover back into
place and use a screwdriver to
tighten the screws back on.
4. To make sure that the transmitter is
working properly, press one of the
buttons to see if the LED indicator
light shows up green.
10. Replacing the Transmitter Battery
+
- +
-
Caution!
If you tighten the screws too much,
it will strip the screws and spin.
The range for the BALL TRAINER PRO is 100 yards, which can vary depending
on the way you use your transmitter. It may also vary depending on
geographical conditions and the surrounding environment.
To get the greatest range, follow the instructions below.
- To improve the range, hold the transmitter in your hand and do not block the
top of the transmitter (there is an internal antenna).
- Get the best range when holding the transmitter away from your body and
placing it above your head.
- Always check the batteries in your transmitter and receiver before usage.
Replace and recharge the batteries if necessary.
- The battery performance will decline when used in colder temperatures
(below 32°F).
12. Maximizing the Distance
Typical range Minimum range Maximum range
1) When inserting the batteries into the transmitter, make sure the battery
matches the positive or negative polarity.
2) Please remove the batteries from the transmitter and fully charge the
receiver battery if it will not be used or placed in storage for a long time.
3) If you are storing the batteries, do not store it together with metal products.
4) If the battery expires, replace the battery with a new one even if it has some
capacity left.
11. Using the Battery Correctly
13. Attaching the Belt Clip
Follow the instructions below to attach the included belt clip to the transmitter.
1. Align the belt clip to the grooves on the back of the transmitter.
2. With a firm grip, screw on the belt clip's Phillips head screws with
a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over tighten.