DOGA XS-40D, Инструкция по эксплуатации

Страница: 5 / 13

Instructions manual / XS-40D
5
1.4 Tool use and Care
- Use clamps or other practical way to secure and support the workplace to a stable platform. Holding the work by hand or
against your body is unstable and may lead to loss of control.
- Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for
which it is designed.
- Do not use tool if switch does not turn it on or off. Any tool that cannot be controlled with the switch is dangerous and
must be repaired.
- Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the tool.
Such preventive safety.
- Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained
users.
- Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with sharp cutting edges are less
likely to bind and are easier to control.
- Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tools
operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
- Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for
one tool, may become hazardous when used on another tool.
1.5 Service
- Tool service must be performed only by qualified personnel. Service or maintenance performed by unqualified personnel
could result in a risk of injury.
- When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of this
manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of electric shock or
injury.
2. Specific safety rules
2.1 Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden
wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operatior.
2.2 Never lubricate aerosol oil on to the electrical part.