Dodge R1500 1999, Руководство по обслуживанию

Страница: 460 / 1691

1) On drive shafts greater than 30" in length, measure runout
3" from transmission flange/yoke, center bearing yoke and pinion
flange using dial indicator. Maximum runout for Ram Pickup is .030" (.
76 mm) at front and rear end of drive shaft and .035" (.89 mm) at
center of drive shaft. Maximum runout for all other models is .010" (.
25 mm) at front and rear end of drive shaft and .015" (.38 mm) at
center of drive shaft.
2) For drive shafts less than 30" in length, maximum runout
for Pickup is .030" (.76 mm). Maximum runout for all other models is .
020" (.51 mm). Replace drive shaft if maximum runout is exceeded.
BALANCING DRIVE SHAFT
1) Perform following procedure only after inspecting all
other possible causes of vibration. See INSPECTION. Drive shaft
imbalance may often be cured by disconnecting shaft, rotating it 180
degrees and reconnecting shaft to flange. Test drive to check results.
NOTE: DO NOT run engine for prolonged periods without forced
airflow across radiator. Engine or transmission may
overheat.
2) To balance drive shaft(s), begin by raising rear wheels
off ground and turning drive shaft with engine. Balance testing may be
done by marking drive shaft in 4 positions, 90 degrees apart around
shaft. Place marks about 6" forward of rear flange/yoke weld. Number
marks 1-4.
3) Install large diameter screw-type hose clamp around drive
shaft so clamp’s head is in No. 1 position. Spin drive shaft with
engine and note vibrations. If there is little or no change in
vibration intensity, move clamp head to No. 2 position, and repeat
test.
4) Continue procedure until vibration is at lowest level. If
no difference is noted with clamp head moved to all 4 positions,
vibrations may not be due to drive shaft imbalance.
5) If vibration decreases but is not completely eliminated,
place a second clamp at same position, and repeat test. Combined
weight of both clamps in one position may increase vibration. If so,
rotate clamps 1/2" apart, above and below lowest vibration level
position, and repeat test.
6) Continue to rotate clamps, as necessary, until vibration
is at lowest point. If vibration can be eliminated or reduced to
acceptable level, bend back slack end of clamp so screw cannot loosen.
If vibration level is still unacceptable, leave rear clamp(s) in
place, and repeat procedure at front end of drive shaft. Road test
vehicle. On 4WD models, perform procedure on each shaft.
CHECKING VERTICAL ANGLE
One-Piece Drive Shafts
1) Raise and support vehicle so rear wheels can be rotated.
Rotate drive shaft so a pinion flange bearing cap faces downward.
Attach Inclinometer (C-4224) magnet to bearing cap, and measure drive
shaft vertical angle. See Fig. 4. Remove inclinometer.
2) Rotate drive shaft 90 degrees until drive shaft rear yoke
bearing cap faces downward. Attach inclinometer magnet to bearing cap,
and measure drive shaft vertical angle. Difference between 2 measured
angles is drive shaft rear angle. See Fig. 5. Remove inclinometer.
3) Rotate drive shaft until a slip joint yoke bearing cap
faces downward. Attach inclinometer magnet to bearing cap, and note
angle. Remove inclinometer. Rotate drive shaft 90 degrees until drive
shaft front yoke bearing cap faces downward. Attach inclinometer
magnet to bearing cap, and note angle. Remove inclinometer.