Dodge Durango SRT 2018, Руководство пользователя

Страница: 27 / 664

To Exit Remote Start Mode Without
Driving The Vehicle
Push and release the remote start button one
time or allow the engine to run for the entire
15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable with a one time push of the remote
start button for two seconds after receiving a
valid remote start request.
To Exit Remote Start Mode And
Drive The Vehicle
Before the end of 15-minute cycle, push and
release the unlock button on the key fob to
unlock the doors, or unlock the vehicle using
Keyless Enter-N-Go — Passive Entry via the
door handles, and disarm the vehicle security
alarm (if equipped). Then, prior to the end of the
15-minute cycle, push and release the START/
STOP button.
NOTE:
For vehicles equipped with the Keyless Enter-
N-Go — Passive Entry feature, the message
“Remote Start Active — Push Start Button” will
display in the instrument cluster display until you
push the ignition START button.
Remote Start Comfort Systems — If
Equipped
When Remote Start is activated, the heated
steering wheel and driver heated seat features
will automatically turn on in cold weather. In
warm weather, the driver vented seat feature will
automatically turn on when the remote start is
activated. These features will stay on through
the duration of Remote Start or until the ignition
switch is placed in the ON/RUN mode.
NOTE:
The Remote Start Comfort System can be acti-
vated and deactivated through the Uconnect
System. Refer to “Uconnect Settings” in “Multi-
media” for further information on Remote Start
Comfort System operation.
SENTRY KEY
The Sentry Key Immobilizer system prevents
unauthorized vehicle operation by disabling the
engine. The system does not need to be armed
or activated. Operation is automatic, regardless
of whether the vehicle is locked or unlocked.
The system uses a key fob and a Keyless Push
Button Ignition, and a RF receiver to prevent
unauthorized vehicle operation. Therefore, only
key fobs that are programmed to the vehicle can
be used to start and operate the vehicle. If an
invalid key fob is used to attempt to start and
operate the vehicle, the system will not allow the
engine to crank. If an invalid key fob is used to
start the engine, the system will shut the engine
off in two seconds.
After placing the ignition to the ON/RUN mode, the
vehicle security light will turn on for three seconds
for a bulb check. If the light remains on after the
bulb check, it indicates that there is a problem with
the electronics. In addition, if the light begins to
flash after the bulb check, it indicates that some-
one used an invalid key fob to start the engine.
Either of these conditions will result in the engine
being shut off after two seconds.
If the vehicle security light turns on during
normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there is
a fault in the electronics. Should this occur, have
the vehicle serviced as soon as possible by an
authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new vehicle
have been programmed to the vehicle electronics.
Customer Key Programming
Programming key fobs may be performed at an
authorized dealer.
Replacement Keys
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
24