Dodge Charger SRT 392 2017, Руководство по эксплуатации

Страница: 69 / 576

NOTE:
If your vehicle is equipped with two key fobs,
one key fob can be linked to memory position
1 and the other key fob can be linked to memory
position 2.
The memory seat switch is located on the
driver’s door trim panel. The switch consists of
three buttons: The set (S) button, which is used
to activate the memory save function, and the
memory (1) and (2) buttons, which are used to
recall either of two pre-programmed memory
profiles.
Programming The Memory Feature
NOTE:
Saving a new memory profile will erase an
existing profile from memory.
To create a new memory profile, perform the
following:
1. Place the vehicle’s ignition to the ON/RUN
position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if equipped],
and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release
memory button (1) or memory button (2). The
instrument cluster display will show which
memory position has been set.
NOTE:
•
Memory profiles can be set without the
vehicle in PARK, but the vehicle must be
in PARK to recall a memory profile.
•
To set a memory profile to your key fob,
refer to “Linking And Unlinking The Re-
mote Keyless Entry Key Fob To Memory”
in this section for further information.
Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory
Your key fobs can be programmed to recall one
of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must
select the “Memory To FOB” or “Personal Set-
tings Linked To Fob” feature through the
Uconnect system screen. Refer to “Uconnect
Settings” in “Understanding Your Instrument
Panel” for further information.
To program your key fobs, perform the following:
1. Place the vehicle’s ignition to the OFF posi-
tion.
2. Select desired memory profile (1) or (2). The
system will recall any stored settings for this
profile. Wait for the system to complete the
memory recall before continuing to step
three.
NOTE:
If a memory profile has not already been set,
refer to
" Programming The Memory Feature " in
this section for instructions on how to set a
memory profile.
3. Once the profile has been recalled, push and
release the set (S) button on the memory
switch, then push and release memory but-
ton (1) or memory button (2) accordingly.
“Memory Profile Set” (1 or 2) will display in
the instrument cluster display.
4. Push and release the lock button on the key
fob within 10 seconds.
Memory Seat Switches
66