DOD TEC4X Скачать руководство пользователя страница 2

2

U.K. MAINS PLUG WARNING

A moulded mains plug that has been cut off from the cord is unsafe.  Discard the
mains plug at a suitable disposal facility.  NEVER UNDER ANY CIRCUM-
STANCES SHOULD YOU INSERT A DAMAGED  OR CUT MAINS PLUG INTO
A 13 AMP POWER SOCKET.  Do not use the mains plug without the fuse cover
in place.  Replacement fuse covers can be obtained from your local retailer.
Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

These symbols are internationally accepted symbols that warn of potential haz-
ards with electrical products. The lightning flash means that there are danger-
ous voltages present within the unit.  The exclamation point indicates that it is
necessary for the user to refer to the owner’s manual.

These symbols warn that there are no user serviceable parts inside the unit.
Do not open the unit. Do not attempt to service the unit yourself. Refer all ser-
vicing to qualified personnel. Opening the chassis for any reason will void the
manufacturer’s warranty.  Do not get the unit wet. If liquid is spilled on the unit,
shut it off immediately and take it to a dealer for service. Disconnect the unit
during storms to prevent damage.

C A U T I O N

A T T E N T I O N :

 

R I S Q U E   D E   C H O C   E L E C T R I Q U E   -   N E   P A S   O U V R I R

W A R N I N G :

 

T O   R E D U C E   T H E   R I S K   O F   F I R E   O R   E L E C T R I C

S H O C K   D O   N O T   E X P O S E   T H I S   E Q U I P M E N T   T O   R A I N   O R   M O I S T U R E

R I S K   O F   E L E C T R I C   S H O C K

D O   N O T   O P E N

WARNING

FOR YOUR PROTECTION, PLEASE  READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a
bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool, etc).  Care should be taken so that objects do not fall and liquids are not spilled
into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of
the type described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the ground-
ing or polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user should not attempt
to service the appliance beyond that described in the operating instructions.  All other
servicing should be referred to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE  FUSE RECEPTACLE:
Replace fuse with same type and rating only.

ELECTROMAGNETIC COMPATIBILITY

Operation  is subject  to the following  conditions:

• this device may not cause harmful interference, and 
• this device must accept any interference received, including interference

that may cause undesired operation.

• use only shielded interconnecting cables.  
• operation of this unit within significant electromagnetic fields should be 

avoided.

DECLARATION OF CONFORMITY

Manufacturer’s Name:

DOD Electronics 

Manufacturer’s Address:

8760 S. Sandy Parkway 
Sandy, Utah 84070, USA

declares that the product:

Product Name:

Tec4X

Product Options:

All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 
60742, or equivalent).

conforms to the following product specifications:

Safety:

EN 60065 (1993) IEC 65 (1985) with Amendments 1,2,3

EMC:

EN 55013: (1990) EN 55020: (1991)

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC
as amended by directive 93/68/EEC.

DOD Electronics 
President
8760 S. Sandy Parkway
Sandy, Utah 84070, USA

Effective: (4/13/98)

European Contact: Your Local DOD Sales and Service Office or 

International Sales Office
3 Overlook Drive #4
Amherst, New Hampshire 03031, USA
Tel: (603) 672-4244
Fax: (603) 672-4246

Содержание TEC4X









Отзывы: