DNP DS-SL20, Руководство по эксплуатации

Страница: 26 / 81

26
Replacing the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
7
Remove the ribbon tray.
8
Remove the ink ribbon.
After removing the ink ribbon, attach the black spool
to the white spool.
Do not reuse ink ribbons that have reached their
prescribed print capacities and have been removed.
The ribbon tray is reusable. Do not throw it away.
Loading the Paper Roll and Ink
Ribbon
For details on loading the paper roll and ink ribbon, see
“Loading the Paper Roll and Ink Ribbon” on page 16 .
When you are finished loading the paper roll and ink
ribbon, touch the [OK] button in the error message screen.
The error message screen closes, and you can continue
operations.
If the Ink Ribbon Breaks during Use
The remaining ribbon can be used after repairing it with
adhesive tape.
1
Open the ribbon door, and remove the ribbon tray.
2
Pull the ribbon on the white spool, attach one edge of
a strip of adhesive tape along the entire length of the
ribbon’s end, and then attach the other edge of the tape
to the ribbon on the black spool.
3
Remove any slack from the ribbon.
Be sure to wind the taped portion completely onto the
black spool so that the tape is not exposed.
4
Hold the center of the ribbon tray, and load it into the
unit.
Always hold the center of the ribbon tray when loading
it into the unit. If you hold the tray by any other part,
your fingers may get caught while inserting the tray
and injuries may result.
Note
Note
Note
(1)
Wind the
spool to feed
the ribbon out.
(2)
Attach the adhesive tape along
the entire length of the white
spool’s ribbon end, and attach it to
the ribbon on the black spool.
Wind the black spool to remove any slack.