DMP Electronics ITI 738I, Инструкция по установке и программированию

Страница: 8 / 24

4 738I ITI™ Installation and Programming Guide | Digital Monitoring Products, Inc.
INSTALL THE 738I ITI™
Mount the Module
Mount on Wall
The module comes in a case that mounts directly to walls, backboards, or other flat
surfaces. Wire entrances are on the back and each side of the case. Two screw holes
at the bottom of the case are for mounting the case on single-gang switch boxes or
rings.
Mount in Enclosure
The module can be mounted in a DMP enclosure using the standard 3-hole mounting
pattern. Refer to Figure 1 as needed during installation.
1. Hold the plastic standoffs against the inside of the enclosure side wall.
2. Insert the included Phillips head screws from the outside of the enclosure into
the standoffs. Tighten the screws.
3. Carefully snap the module onto the standoffs.
1