DMP Electronics eBox-2300SX, Руководство пользователя

Страница: 20 / 27

eBox-2300SX
12
T
ROUBLESHOOTING
This section describes the techniques of resolving some basic problems that you
encounter when using eBox-2300SX. For more troubleshooting guidelines, please
contact your nearest dealer for technical support.
T
ROUBLESHOOTING
Y
OUR
VESA PC
A. VESA PC does not start
Make sure the eBox-2300SX is properly secured and plugged into a power source
before it is turned on. Make sure the power indicator shows the power is on. See
section 2 for more information about “eBox-2300SX Overview”.
When the eBox-2300SX is plugged into a power strip or the UPS (Uninterruptible
Power Supply), make sure the power strip or UPS is turned on and working normally.
Check if your VGA or LCD monitor is properly plugged into a power source and
turned on. Make sure the brightness and contrast controls are adjusted correctly.
See the manual that came with your display (monitor) for details.
Check if your power control button does not function, by removing the AC adaptor.
Wait for one minute, and then reattach all power connection before pressing the
power button.
Condensation may cause the eBox-2300SX to malfunction for a while. If this
happens, do not use the eBox-2300SX for at least one hour.
When you have checked all the above guidelines and the eBox-2300SX does not
work. Remove the power adaptor from the eBox-2300SX, unplug the power cord,
and plug it in again. Then turn on the power.
B. BIOS Error Message –
BIOS error message appear when my VESA PC starts
If the BIOS error message appears, press any key to resume or, hit <DEL>to enter
BIOS setup main menu, follow these steps:
1.
Press <DEL>, and the BIOS Setup main menu appears, check if HDD is detected
at “Pri Master”. If it is not detected, use “Sel” keys <
↑↓ > to choose “AUTO” and
then go back to the main menu by pressing <ESC>. Move your cursor down with
“Sel” keys <
↓ >, and choose “Save Settings and Exit”, a message dialog appears
as seen below, hit <Enter>.
“Save current settings and exit (Y/N)? Y”
2.
Go to “Auto Configuration with Optimal Settings” using the “Sel” keys < ↑↓ >, then
press <Enter>. A message dialog appears as seen below, hit “Y” key and press
<Enter> to save and recover the factory setting.
“Load high default settings (Y/N)? N”
8