DESCRIPTION
Figure 1: 263LTE-FN
The 263LTE-FN Cellular
Communicator provides
a fully-supervised alarm
communication path over a
reserved AT&T network. The
module installs on the panel
inside the enclosure and is
powered by the panel so no
additional enclosure, power
supply, or battery back-up is
needed.
The 263LTE-FN is
FirstNet Ready™.
Compatibility
• XR150/XR550 Series
panels with Version 202 or
higher
• XT30/XT50 Series Panels
with Version 202 or higher
What is Included
• 263LTE-FN Cellular
Communicator
• 383 antenna
• PCB standoff
• Hardware pack
1
INSTALL THE 263LTE-FN
Caution:
Touch grounded metal to discharge
static before handling the panel.
XT30/XT50 Series Panels
1. Open the panel enclosure, set the reset
jumper, and remove power from the panel.
2. Insert the included standoff into the
panel standoff hole.
3. Align the 263LTE-FN SMA antenna connector
with the antenna hole in the top of the panel
enclosure, place one washer around the
connector, and secure it on the 12-pin cell
module connector. See Figure 2.
Note:
For XT50 panels, install the included
washers between the antenna and the panel.
4. Align the 263LTE-FN standoff hole with the
standoff already placed in the panel and
snap it into place.
1
2
3
4
Figure 2: 263LTE-FN on an XT30/XT50 Panel
Back of the
263LTE-FN
Standoff and
Standoff Hole SMA Connector
Figure 3: 263LTE-FN on an XR150/XR550 Panel
Standoff and
Standoff Hole
Back of the
263LTE-FN
XR150/XR550 Series Panels
1. Open the panel enclosure, set the reset
jumper, and remove power from the panel.
2. Insert the included standoff into the
XR150/XR550 Series panel standoff hole.
3. Secure the 263LTE-FN on the 12-pin cell
module connector. See Figure 3.
4. Align the 263LTE-FN standoff hole with the
standoff already placed in the panel and
snap it into place.
Washer (XT50 only)
263LTE-FN CELLULAR
COMMUNICATOR
Installation Guide
