DMEGC Photovoltaic Modules Installation Manual
- 2 -
building permit if necessary.
The electrical characteristics are within ±3 percent of the indicated values of Isc, Voc and Pmax under
standard test conditions (irradiance of 1000 W/m², AM 1.5 spectrum, and a cell temperature of 25 °C
(77 °F) ).
Only use equipment, connectors, wiring and support frames suitable for solar electric systems.
Always use fall protection equipment when working from heights of 6 feet (183cm) or above. Follow
Occupational Safety and Health Act (OSHA) or local governing safety regulations regarding Fall
Protection. (UL Only) .
Do not sit, stand, step or walk on any side of the module, including the frames. Do not permit any part
of the module(s) to be submerged or allow for constant water to soil the module(s) unless it's natural
rain fall or periodic cleaning.
2.2 Operating safety
Do not open the package of DMEGC Solar Modules during transportation and storing until they are
ready to be installed.
Store pallets in a ventilated, rain-proof and dry location until the Modules are ready to be unpacked.
During the transportation, do not to apply direct pressure on the backsheet or front glass.
.
Inappropriate transport and installation may break the module and void the warranty.
Do not lift the module by holding the module’s junction box or electrical leads. Do not place any
heavy or sharp objects on the module.
Do not attempt to disassemble the modules, and do not remove any attached nameplates or
components from the modules.
Do not use mirrors, other magnifiers or artificially concentrated sunlight onto the modules.
Do not apply paint or adhesive to the module top surface or backsheet.
To avoid damage to the backsheet and cells, do not scratch, dent or hit the backsheet.
Do not drill holes in the frame. This may compromise the frame strength, cause corrosion of the frame
and void the warranty.
Do not scratch the anodized coating of the frame (except for grounding connections at the grounding
connection point on the back side of the module). It may cause corrosion of the frame or compromise
