DMC FFD-120-WH, Инструкция по установке и эксплуатации, Страница: 15 / 22

5. Instructions
PNEG-258 Scattergrain Grain Spreader 15
Adjustment for Bin Fill
1. Rotation is always viewed from top of the unit looking down on to the blade.
2. Be sure to fully tighten all bolts after each adjustment is made.
3. These adjustments describe the requirements for both extremes of bin sizes. For bin sizes between
24" and 36" in diameter, start with intermediate adjustments and vary slightly as required to reach
desired results.
Large Bin
36" Diameter and Greater
Small Bin
24" Diameter and Less
Ref # Part Type Operation/Procedure Operation/Procedure
1 Spreader Blade Tilt
Decrease (flatten)/loosen U-bolts and
pivot the blade to horizontal. Always
refer to single diverter side as gauge.
Increase/loosen U-bolts and pivot the
blade (single diverter side) upward.
2
Spreader
Diverter
Single Side
Decrease (center filling)/loosen bolts
and rotate diverter clockwise. Increase (center filling)/loosen bolt and
rotate diverter counterclockwise.
Dual Side
Decrease (center filling)/loosen bolts
and rotate diverters clockwise to direct
flow in line with grain stream. Increase (center filling)/loosen bolt and
rotate diverters counterclockwise to
direct flow across grain stream.
3 Blade Extension Tilt
Increase/loosen bolt and pivot the
extension upward to maximum
allowance in slotted hole.
Remove blade extension.
4 Damper Opening
Decrease (center filling)/loosen
bolts and pivot dampers to nearly
closed position. Increase (center filling)/loosen bolts
and pivot dampers to almost fully
open position.