DLX ASAP Скачать руководство пользователя страница 2

ASAP

®

 

REPAIR 

PROUDLY MADE IN THE USA. // CAGE CODE: 7CFK2 // DUNS #: 079751064 // SBA 8(A) CERTIFIED // © 2021 DLX ENTERPRISES LLC

Cut patch 1 inch beyond all edges of the tear. If using more than one patch, overlap at least 

1 inch. Trim and round corners. 

Peel back 1/2 inch of paper liner.

Position exposed edge - allowing the patch to extend 1 inch beyond all edges of the tear. Peel 

back the liner while applying the patch over tear. Follow steps 1-3 on the back side of the repair if 

you have access to the backside.

 

Turn the material over so that the adhesive side of the tab is facing up.

Position reinforcement filament tightly against the outside edge. The filament should be 

perpendicular to the open end of the tear to create a tough solid edge.

Fold over the patch’s 1 inch tab and rub to adhere to the backside of the material.

Apply another patch to the backside of the patched tear (so that both sides of material are 

patched). Rub the entire patch aggressively.

 NOTE: HEATING IS AN OPTION AND NORMALLY NOT NEEDED UNLESS TEMPERATURES ARE BELOW FREEZING.

 1

 2
 3

 4

 5

 6

 7

Tear on Edge

Fold 1 inch Tab Over Filament

Apply Leaving 1 inch Tab Beyond Edge

Apply Reinforcement Filament

Apply to Back Side

Cut Filament to Width of Patch

Repairing tears extending through and outside edge

GENERAL SETUP

Follow steps 1-3 with the following adjustments:

- Cut the patch size to extend a full 1 inch beyond the edge of the torn material

- Peel and stick, positioning the patch with a 1 inch tab beyond the outside edge of the torn material

Отзывы: