DLS REFERENCE SPEAKERS
OWNERS MANUAL
Welcome
Thank you for buying a DLS speaker. This model is a part of
DLS Reference speaker line.
Install the speakers yourself if you feel confident with our in-
structions and if you have the proper tools. A poor installation
job can destroy the final result even from these speakers, so if
you feel unsure, turn over the installation job to someone better
suited to it.
Installation
Mount the woofer in the car door. Normally they will fit in the
facory pre-made mounting holes. If you want an improved
sound reinforce with a baffle of MDF-board or similar. An in-
stallation high up on the door side is to be prefered.
The wide band tweeter should be installed in the dashboard or
in the A-pillar directed on-axis towards the listener.
Connect the speakers to the crossovers as in this drawing:
Technical Assistance
For technical assistance ask the shop where the product was
sold or the distributor in your country.
You can also send an e-mail to [email protected]
Information can also be found on our web-site www.dls.se
We follow a policy of continuous advancement in development.
For this reason all or part of specifications & designs may be
changed without prior notice.
Warranty service
This speaker is covered by warranty, depending on the condi-
tions in the country where it is sold. If the speaker is returned
for service, please include the original dated receipt (or a copy)
with the product.
Installation of wide band tweeter RC50
- We recommend installation in a closed box 0,2 - 1 litres
volume.
A low x-over point reqiures a larger box volume,
a higher x-over point accepts a smaller box.
- Installation on axis is strongly recommended for a good
result.
- Recommended x-over frequency for active crossover use is
1500 Hz or higher, use 12 dB slope.
- Connect with a good amplifier like DLS CC series or better.
Technical data RC50 wide band tweeter
DLS Svenska AB
P.O Box 13029
SE-40251 Gothenburg
Tel: +31840060
Fax: +31844021
E-mail: [email protected]
www.dls.se
Art.no. for driver
8-23050
Impedance
4 ohm
Size
50 mm / 2”
Nom. power handling (RMS) 50 Watt, 80 Watt max
Fs
155
Hz
Frequency response
500 Hz - 22 kHz
Rec. freq. use
1500 kHz - 22 kHz
Sensitivity
83,2 dB
Magnet diameter
32 mm /1,26”
Outer diameter
84 mm / 3,3”
Mounting depth
37 mm / 1,46” (recessed install)
Mounting hole
65 mm / 2,56” (recessed install)
Cone material
Fibre glass
RZ6.2
2-way
system
Technical data RZ6.2 woofer
Art.no. for driver
8-23161
Impedance
4 ohm
Nom. power handling (RMS) 100 Watt, 150 Watt max
Cone material
Pressed paper
Woofer size
6,5”(16,5 cm)
Magnet size
100 mm/4”
Sensitivity
85 dB
Mounting depth
70 mm/2,76”
Mounting hole
145 mm / 5,7”
Fs / Qts / Vas
64 Hz / 0,78 / 6,3 litres
Connection of crossover RZ6.2
Black -
DLS RZ6.2 crossover
Connection of one channel, the
other is connected in the same
way.
Head unit /
amplifier
- +
+ IN - + WF- +
TW -
Red + Black -
Tweeter
