The amplifiers include
RCA inputs
High Level input
Variable low pass crossover (not RA25)
Variable high pass crossover
Grand bass feature 0 - +18 dB (not RA25)
Phase shift continously variabel 0-180 degr.
(not RA25)
Remote turn on / off
Automatic remote turn on/ off on high level
input without connecting any remote wire
Electronic protection circuitry against
short-circuit, DC offset and thermal overload.
Installation
Before you begin installation
Before you begin you need to read the manual, to have
some tools, cables and other material available. There
is one such list of material on the following page.
Amplifier location
Important
Allow air circulation around the amplifier.
2
Disconnect Battery
Before starting the instal-
lation, always disconnect
the negative terminal of
the battery.
The DLS Reference series of amplifiers have a
compact design that allows great flexibility in
mounting. You can mount it under a seat or in the
trunk.
When you select a location, do remember that the
amplifier generates a lot of heat.
Choose a location where air can circulate freely
around the amplifier. Do not cover the amplifier
with carpets or hide behind trim panels.
Do not mount the amplifier in an inverted or upside
down position.
Check all locations and placements carefully
before making any cuts, drilling any holes or ma-
king any connections.
This is the best way to
mount the amplifier to get
the best cooling.
RA25 & RA30
RA25
2 x 70 Watt RMS in 4 ohm
2 x 110 Watt RMS in 2 ohm
1 x 220 Watt RMS in bridge mode (4 ohm load)
RA30
2 x 70 Watt RMS in 4 ohm
2 x 100 Watt RMS in 2 ohm
1 x 265 Watt RMS on mono channel (4 ohm load)
All above RMS power ratings at 13,8 Volt DC
DLS logo on amplifier cooling flange
The DLS logo on top of the amplifier is attached
with two hex. screws. The logo can be removed
and twisted 90 or 180 degrees, and then screwed
back in wanted position. The logo can be mounted
in four different ways to match your installation.
