Connect left and right speaker wires coming from
the car stereo to the high level input as shown. You
must connect both plus and minus as the inputs are
balanced, connecting plus only gives lower level and
bad sound quality. By changing the polarity of plus
and minus, you can change the phase.
CCi500 / CCi500-40 / CCi2
On these two models you connect as in this example:
CCi500 / CCi1000 are marked R and L instead of
CH1 / CH2.
CCi4 / CCi44 / CCi44-40
The four channel amplifier is connected likewise,
however we have four channels.
You can feed two channels from RCA and two chan-
nels using high level input from rear speaker cables,
or all channels from high level input.
Important
Use either the low level or high level input, do not
use both at same time.
Low level input
Use a pair of shielded stereo audio cables with RCA
type jack. Most trunk-mount amplifiers need a 20
feet RCA cable ( appr 5 – 6 meters).
Connect to input socket
CH1 / CH2 on CCi2.
Or
R/ L on CCi500 /
CCi500-40.
CCi4 / CCi44 / CCi44-40
has dual inputs
CH1 / CH2
/ CH3 / CH4
Depending on your chosen configura-
tion you can use either two separate RCA cables,
or a single RCA cable together with an Y-split to
connect both inputs.
Remote terminal ( REM )
Low level Input Wiring
Inputs may be low level from the RCA output of the car
stereo or high level from the car stereo speaker output.
Low level = RCA is to prefer for the best sound quality.
4
For RCA cable signal input:
Connect the radio power antenna lead = remote
turn on/off from the car stereo to the amplifier
remote connection. This turns on the amplifier
whenever the car stereo is turned on. You can either
use the built in remote cable in the RCA cable itself
or use a separate cable.
Sometimes a small disturbance may enter the amp-
lifier coming from the remote voltage , through the
built in remote wire and into the RCA cable. Thus
we recommend to use a separate remote wire and
run the RCA lead separate from remote wire, power
cables and speaker cables.
If there is no remote voltage available from the
stereo, you must connect to the ignition key through
the radio or any accessories fuse.
When high level input is used the amplifier starts
automatically when your car stereo is switched on.
To head unit Power
Antenna lead or
remote output.
A cable up to AWG 14 (2,5 sq
mm) fits the amplifier remote
(REM) terminal
.
High Level Input wiring
For High Level input:
Most headunits are pre-installed from the car factory
and have no RCA output, in this case you can take
the signal from the speaker output instead.
Use either a sepatate remote cable or let the high
level signal automatically start the amplifier.
Hi level input plug.
White: CH2 (R)+
Green: CH2 (R) -
Brown: CH1 (L) -
Grey: CH1 (L) +
Hi level input plug.
White: CH1 +
Green: CH1 -
Brown: CH2 -
Grey: CH2 +
Hi level input plug.
Orange: CH3 +
Pink: CH3 -
Blue: CH4 -
Yellow: CH4 +
CH1 CH2
+ - - +
HIGH INPUT
CH1 CH2
+ - - +
HIGH INPUT
CH3 CH4
+ - - +
HIGH INPUT