DLP Texas Instruments DH85FAA, Руководство пользователя

Страница: 32 / 68

–
23
–
CONTROL Menu
Direct Power On On/Off
Light Source Light Mode:
Normal, ECO, Dynamic ECO
Light Hours Reset
High Altitude Normal / High
IR Control Front+Rear IR On/Front IR On/
Rear IR On
Remote ID Default(0)/ 1/ 2/ 3/ 4/ 5/ 6/ 7
Network Network State: Connect,
Disconnect
DHCP: On/Off
IP Address:
0~255,0~255,0~255,0~255
Subnet Mask:
0~255,0~255,0~255,0~255
Gateway:
0~255,0~255,0~255,0~255
DNS: 0~255,0~255,0~255,0~255
Apply: OK/Cancel
Direct Power On
Use ◄/► to switch ON/OFF
This function is set to OFF by default. When it is set to ON, the projector will turn on automatically
when the AC power is turned on the next time. You can use this function and the power switch
(instead of the remote control) to turn on the projector.
Light Source
Press
and use ▼/▲ to scroll through submenus
●
Light Mode: use ◄/► to select (Normal, ECO, Dynamic ECO)
●
Light Hours Reset: After replacing the lamp, this item should be reset. See page 37 for more
information on Light Hours Reset .
High Altitude
Use ◄/► to adjust cooling fan speed (Noraml, High)
IR Control
Use ◄/► to select the prefered IR control location (Both IR On Front IR on, Rear IR On)
This function let you select which IR remote controller receiver is active.