3
Note: If you intend to use an external antenna (purchased separately) with the DLP-RFID2-EDK2
module, you must first disable the on-board antenna by removing Resistor R2. A PCB position (SMA1)
is available for mounting an SMA connector [Ex: CONSMA003.062 (purchased separately)].
5. Mount the two provided male headers to the DLP-RFID2 module. Carefully solder these two headers
in place, ensuring that no solder bridges are created between adjacent pins.
Note: If you only want to reprogram (not debug) the firmware in the RFID2, then these connectors are
not required. The small adapter PCB's 2mm male header can be held in place by hand for the few
seconds required by the program process.
6. Mount the DLP-RFID2 module to the DLP-RFID2-EDK2 PCB as shown below. Pay attention to the
orientation of the RFID2 module relative to the DLP-RFID2-EDK2 PCB. The RFID2 module must not be
plugged in backwards.