Operation of the clock radio
General operation
Switching on
First switch the mains switch on the unit's rear panel to the "I" position. The device is
now in standby mode and the display will be illuminated by dim blue light.
To turn the system on, press
button on the front panel or on the remote control.
The blue display will then brightly be illuminated and the system is working. You can
change the mode by pressing the
FUNCTION
button repeatedly:
TUNER
-
UDISK
(USB flash media) -
SD/MMC
(memory card) -
AUX
Setting the time
1. To do this, press the
ENTER
button once. “
CLOCK
” will then show. Press the
4;
button on the remote control, then the hour digits will start to flash.
2. Now you can enter the actual hours in the present time using the
9
/
:
buttons.
To confirm, press
4;
on the remote. Then the minute digits will start to flash.
3. Now you can set the minutes of the actual time using
9
/
:
. To confirm, press
4;
. To confirm, press
4;
on the remote. The time is now saved.
Changing the volume
To increase the volume, turn the
VOL
knob in a clockwise direction. To reduce the
volume, turn the knob in the opposite direction. Alternatively, you can also regulate
the volume using the
VOL +
/
—
buttons on the remote control. To mute the
volume, press
. Press the button again to turn the volume back on
EQ presets
We have programmed some EQ sound settings into the system which you can call up
for the music you are playing. Press
EQ
repeatedly to activate the following
settings:
ROCK
,
JAZZ
,
CLASSIC
,
POP
, . The first time you press this button, the current
setting will be displayed. FLAT stands for “neutral”.
Headphone operation
You can connect a headphone to the EARPHONES jack on the rear panel of the
device using a 3.5mm jack plug. This deactivates the built-in speaker.
Be careful with regard to your hearing. A too high volume may lastingly
impair the hearing ability of your ears.
BASS
If you would like to boost the low frequencies in 3 levels, repeatedly press the
BASS
button. Press the button again to deactivate this function.
Switching off
To switch the unit off, press the
button. As this doesn’t disconnect the device from
the mains you should switch off the mains switch on the rear panel if you’re not
going to use the device for a longer period of time. In this case the clock time is not
saved. After switching on the device you have to reset the clock.
8
