djm direct DJMBD13-40, Оригинальное руководство по эксплуатации

Страница: 13 / 18

12
12. Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the electrical tool.
Danger! Store the drill press a way it
cannot be started by unauthorised
persons and that nobody can be injured.
Caution! Do not store the drill press
unprotected outdoors or in a moist
environment.
Problem Cause Remedy
Device doesn‘t start.
1. No mains voltage.Main circuit breaker is
tripped.
2. On switch (green) / Off. Switch (red) (1) is
broken.
3. Motor faulty.
1. Check the socket, mains supply cable, cord,
mains plug; if necessary, have them repaired
the main fuse.
2. Repair by Customer Care.
3. Repair by Customer Care.
No Motor
output turns off
automatically
1. Motor not fixed in place.
2. Bit not centrally clamped.
1. Check the tension of the V-belts and tighten
the clamping screw.
2. Check the bit in the drill chuck.
Loud squeaking noise. 1. Incorrect belt tension
2. Dry spindle
3. Loosed spindle pulley
4. Loosed motor pulley
1. Adjust the belt tension
2. Lubricate the spindle
3. Tighten the retaining nut on the pulley insert
4. Tighten the set screw on the side of the
motor pulley
The drill bit burns or
smokes
1. Drilling at the incorrect speed 2. The wood
chips are not
coming out of the hole
3. Dull drill bit
4. Feeding the workpiece too slowly
5. Not lubricated
1. Change the speed
2. Retract the drill bit frequently to clear the
chips
3. Resharpen or replace the drill bit 4. Feed fast
enough to cut the
workpiece
5. Lubricate the drill bit with cutting oil
Excessive drill run out
or wobble;drilled hole
is not round
1. Bent drill bit
2. Bit improperly installed in the chuck
3. Worn spindle bearings
4. Lengths of cutting flutes or angles not
appropriate for the hardness of the wood grain
5. Chuck not properly installed
1. Replace the drill bit
2. Reinstall the bit.
3. Replace the bearing. Take the press to a
qualified service technician
4. Resharpen the drill bit correctly or replace
with the appropriate type.
5. Reinstall the chuck.
Drill bit binds in the
workpiece
1. The workpiece is pinching the bit 2. Excessive
feed pressure
1. Support or clamp the workpiece. 2. Feed
more slowly.
Spindle returns too
slowly or too quickly
Coil spring has improper tension Adjust the coil spring tension
Trouble Shooting