dji GOGGLES Racing Edition, Быстрый старт

Страница: 4 / 16

1. Camera Port
Connect with the DJI OcuSync Camera. Note
that both this port and the camera connector
plug are customize Type-C interface and they
are not compatible with third-party equipment.
2. SBUS Port
Connect with the 3 in 1 Cable(power, S.Bus,
UART), and connect to power, flight controller
and the OSD port based on the sequence
below.
RED: Power
BLACK: Power GND
GRAY: UART RX(Connects toOSD)
WHITE: UART TX (Connects toOSD)
BROWN: GND
YELLOW: SBUS(Connects toFlight Controller
RX)
3. Micro SDCard Slot
Insert Micro SD Card to store the video
recorded.
4. Antenna Ports
Used to attach the Air Unit antennas.
5. Micro USB Port
Connects to your PC for firmware
upgradesthrough the DJI Assistant 2.
6. PPM Port
Connects to the aircraft’s gimbal with the
PPM Cable to control the aircraft or gimbal by
DJI Goggles. (supported later)
7. Link Button
Press this button to link the DJI OcuSync Air
Unit with the DJI Goggles.
8. Linking Status Indicator
Indicate the linking status of the DJI OcuSync
Air Unit and the DJI Goggles.