5 / 10
5. Bedienung
5.1. Installation
-
After ensuring all the accessories are intact, position the machine no a flat surface, and open
the flight of the machine.
-
Take out the unit from the shipping packing, make sure all the foams and plastic padding are
removed, especially in the nozzle areas.
-
Place the unit on a flat surface and remove the tank cap.
-
Place the liquid tube into the tank.
-
Fill the tank with high-quality, water-based fog liquid recommended by the distributor. Any
other types of liquids may cause spraying water or serious clogging problem. After infusing
liquid, seal the tank with cap. Be careful that the liquid should not exceed the maximum level.
Do NOT OVERFILL.
-
The cable has a special design of tenon at the plug to ensure the cable locking in with proper
outlet. Please make sure the required and provided electricity voltage and the electricity outlet
is a grounded connection.
-
Turn on the power switch, the machine will heating up immediately, and the control board will
display “HEAT”
It requires about 4minutes for heating up. When the process of heating up complete, the display page
will change to the corresponding page, the acquiescent is ADDR. Press the spray button on the
machine or the “ON” button on the w-4 controller, the machine will start spraying.
5.2. Explanation of menu and display
5.2.1. Explanation of the buttons
Menu
：
To transform the main pages of the digital display circularly, press the button. There
are four main pages including menu, up ,down ,enter of DSK-1500.( specified
instruction as follows)
UP:
To increase the amount of parameters under each sub menu.
Down:
To decrease the amount of parameters under each sub menu.
ENTER:
To enter or exit the sub menu