◐
PRECAUTION
◐
FE ATURES
◐
HOW TO INSTALL
1. Do not install the camera outdoors.
2. Choose an ideal location for the camera, since a camera unit must
be protected against moisture and vibration.
3. Be careful not to scratch the camera unit, especially lens or dome cover.
4. Use the camera within the temperature(- 10 ~ +50).
5. Handle with care. Dropping it can cause serious damage to the camera.
6. Avoid any direct sun light toward the lens.
7. Use the AC adaptor 12V DC, 500mA regulated.
1. This camera is incredibly flexible to install with its 3- axis camera con-
struction, which makes the camera ceiling, wall or slope mountable.
2. 15M range visible in tatal darkness with 14pcs of IR LED
3. RS- 485 interface(Pelco- D, Pelco- P protocol support) : option
4. Advanced High Resolution(600 TV- Line) : option
5. Support 4 different privacy zone
6. IR LED output level controllable via RS- 485
7. DWDR(Digital Wide Dynamic Range)
8. Multi function : High Light Mask, Lens Shading Compensation, Impact
Detection, Motion Detection
9. Multi- language full OSD support
Pushing the latch button.
1. Opening the dome :
<
>
Remove the protection sheet after installing.
C aution
3- AXIS IR DOME CAMERA
MANUAL
PROTE CTION S HEET
LATCH BUT TON
2. Removing the dome
3. Camera installation
:
:
Lift the dome. When you push the latch
button, it is unlocked and you can lift the dome.
(1) Fix the camera set with the s upplied screws on ceiling or wall
mount. If you don't use supplied screws, the camera may fall off.
(2) Please refer to '4. Camera angle adjustment' regarding adjust
camera angle.
(3) Re- assemble the camera.
<Ceiling mount>
<Wall mount>
SCREW TP13.5x20 2EA
SCREW TP13.5x20 2EA
4. Camera angle adjustment :
(1) Pan adjustment
(2) Tilt adjustment
(3) Roll adjustment
: Grasp the disk of camera and then adjust
direction to the right or left(- 180 ~ 180 )
: Grasp the led cover of camera and then adjust
direction to the up or down(6 ~ 90 )
: Grasp the camera holder and then rotate
(- 178 ~ 178 )
˚
˚
˚
˚
˚
˚
DIMENSION
ASSEMBLY
<Caution>
If you try to adjust the camera out of limited angle, it might cause
troubles and damage to camera.
If the product is to be put out of operation definitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
CAMERA HOLDER
LED COVER
DISK
ROTATION
U
D
R
L
Ø 84
Ø 110
Ø 85
BOARD CAMERA AS S'Y
CABLE
BASE
BODY
DOME COVER
SC REW
DISK
CONTROL PCB
PUSH BUTTON
SC REW
SCRE W
BUSHING RUB BER
HARNESS
DOIRP3000F
