Dixon 8000 SERIES ZTR, Руководство оператора

Страница: 27 / 39

27
HYDROSTAT DRIVE BELT REPLACEMENT PRO-
CEDURE:
(The hydrostatic drive is equipped with a manual belt take-up).
A. Remove the 3/8" locknut, washers, and rubber spacer from the rear
of the assembly.
B. Allow the idler arm/pulley to swing forward towards the fornt of the
mower. Remove old belt if required. Replace with new belt.
C. With the belt in place on all pulleys, reinsert the rubber spacer, wash-
ers, and 3/8" locknut. Tighten 3/8" locknut until rubber spacer is
deflected approximately 1/8" to 3/16". Make sure belt is not too tight.
Belt deflection or movement should be approximately
1/4" to 1/2" when measured at mid-point between hydro and idler pul-
ley.
Hydrostat Drive
Pulley
3/8" Pin and Rue-Ring
3/8" bolt, lockwasher & heavy
washer
Idler
Pulley
Motor Pulley
Hydrostat Drive
Belt
HYDROSTATIC TRANSMISSIONS:
Before each use, check to be sure that the cooling fins of the hydrostatic
transmissions are clean. Excessive accumulation of oil, dirt, or trash
may cause the transmissions to overheat. NEVER WASH ACROSS TOP
OF RESERVOIR WITH WATER OR STEAM. Fill reservoir as required per the
maintenance schedule listed in this book.
new instructions & graphics.
CARE AND MAINTENANCE