5
CAUTION
● Do not drop or abuse the tool.
● Whenever a tool is not being used, position the Power Switch to the “OFF” position and unplug the power cord.
Attaching / detaching bit and bit type
Push up the holder clamp by fingertip, and it will be unlocked. Thus, the bit can be freely attached and detached
(single finger notion type) select such a bit whose shank is equal to the size shown below.
Insert the power plug into a receptacle and set the changeover switch to “
F
”
position.
Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to
start the motor running.
When the screw is tightened and reach the torque that you had set. The tool will stop automatically. To
reset the tool by releasing the lever to the original position or releasing the bit From the screw head. To
return the screw, set the changeover switch to “
R
” position.
Maintenance and Inspection:
1. The screw driver must be operated in top condition, one day working hour must be
not more than eight hours.
2. Please note don’t let the motor get over heated, every minute use 10~15 screws to operate.
3. The frequency use of this electric screw driver is over than eight hours a day, still it needs periodically testing and
treatment. Every 5-6 months.
4. Inspect tool cords periodically and if damaged, have them repaired by an authorized service facility. Inspect
extension cords periodically and replace if damaged.
5. Do not remove any labels. Replace any damaged label.
Servicing
Description of Operation
