6
Manual / Function
1.
Full auto shut-off screwdriver:
It stops automatically when the screw has been tightened up and reached the set-up torque level.
The device will not cause damage of task since no continue running after screws are tightened.
(1) Trigger switch:
The LED lights on when the trigger switch has been pressed about one-third down, and then the
screwdriver starts functioning when the switch trigger has been pressed half way down; on the
contrary, it stops when the screw has been tightened up or the trigger has been released.
(2) Forward / Reverse switch:
When the switch turn to the right as arrow indicates, the screwdriver will be clock-wise
screwing to tighten things up; Vice versa, left switch means to release the screw. As the diagram
showing, always set the switch to neutral position when the screwdriver is not being used.
Forward (screw) Reverse (unscrew)
(3) LED light:
While press the trigger, the LED lights up automatically to assist the job to be done; on the
contrary, it will be off once the trigger has been released.
(4) Bit Sleeve:
Switch the screw bit and compatibility, pull the head of the type B screwdriver, and install the
bit according to the diagram below, after installing the bit please also install the W type cap and
push it in following the arrow indicated on the diagram below on diagram #2.
Pull the bit holder
Insert the bit
Insert adaptor follow
by socket
Diagram 1
Diagram 2