6
1. Full auto shut-off screwdriver:
Manual / Function
It stops automatically when the screw has been tightened up and reached the set-up torque level. The
device will not cause damage of task since no continue running after screws are tightened.
(1) Trigger switch:
The LED lights on when the trigger switch has been pressed about one-third down, and then the
screwdriver starts functioning when the switch trigger has been pressed half way down; on the
contrary, it stops when the screw has been tightened up or the trigger has been released.
(2) Forward / Reverse switch:
When the switch turn to the right as arrow indicates, the screwdriver will be clock-wise screwing to
tighten things up; Vice versa, left switch means to release the screw. As the diagram showing, always
set the switch to neutral position when the screwdriver is not being used.
(3) LED light:
Forward (screw)
Reverse (unscrew)
While press the trigger, the LED lights up automatically to assist the job to be done; on the contrary,
it will be off once the trigger has been released.
(4) Bit Sleeve:
Switch the screw bit and compatibility, pull the head of the type B screwdriver, and install the bit
according to the diagram below, after installing the bit please also install the W type cap and push it
in following the arrow indicated on the diagram below on diagram #2.
Pull the bit holder
Insert the bit into
Diagram 1
insert adaptor
follow by socket
Diagram 2
