Division-Furtive Type 50, Руководство по эксплуатации

Страница: 19 / 22

19
ENGLISH
device flat on a table with the watch on top of it.
Problem: Watch did not received a full attempt from
programming device.
Solution:
Make sure you wait at least one full attempt, i.e.:
the orange progress bar moves from 0 to 100%. You have
5 attempts. Each attempt is illustrated by one notch on the
white progress bar.
Problem:
Watch receives a poor quality light signal.
Solution:
To determine the quality of the light signal
received, put the watch in programming mode and place
the light sensor over the black and white squares below
(assuming this manual is displayed on your programming
device). On each square, the top cursor should not fluctuate
. On the 0-------1 scale, the top cursor should be near 0
over the square black square and near 1 (without reaching
it) over the white square. There should be at least three
notches between the white square reading and the black
square reading. Make sure the document is zoomed such
as each square outline is bigger than the watch’s diameter.