Usage and cleaning notes
:
●
There is a “break-in” period for a new/clean donut - load
slightly more during this time (first 5-10 loads)
●
There is a “sweet spot” where new loads and reclaim are balanced using cool down hits can extend this time. Finish each session with a full
–
unpowered cool down hit. Holding your mod upside down after a hit will let the reclaim drop down on the bottom of the donut for vaping. Holding
the atomizer at a
slight angle and rotating in a circle while hitting it will help the hot oil touch the bottom of the donut and vaporize.
●
Once past the “sweet spot” the excess reclaim must be removed. I use a tightly rolled up paper towel for this. Roll the paper towel like a
cigarette (flat end) and insert into the atomizer. Hold it upside down and fire it to heat the reclaim. You can assist this process by blowing
through one air intake while covering the other. Rotate the paper towel to clean the walls too. Finally, re-roll the paper towel with a pointed end
and work the center and sides of the donut soaking up most of the reclaim. This will extend the time between break down cleanings.
●
Eventually a full break-down cleaning will be required as the donut will have some buildup and taste will be affected. New donut/cups are cheap
and you can save time by just q-tipping the base and replacing the donut and cup, but you can also clean donuts and cups to original condition
and use them for 6 months or longer.
●
Matt has an excellent video on cleaning using your mod -
https://www.youtube.com/watch?v=P6RuAjzqY_A
●
I clean with isopropyl alcohol (ISO) and a torch. First note the cold resistance of your atomizer it should not change with this procedure.
–
Remove the outer cover from the base by removing the three screws and wipe down the mouthpiece and base cover. Carefully separate the
donut and cup by removing the two post screws. Straighten the leads with a needle nose pliers and carefully slide the donut out of the cup.
This takes some finesse because reclaim will lock the leads in the holes. Put the cup back in the ISO and
gently grab the donut leads with a
locking pliers and use a torch to burn the crust off the donut. Move the torch frequently and do not cherry the donut the goal is just to burn
–
off any buildup. While the donut cools, torch the cup until clean. When all parts are cool, reassemble the atomizer and check that the cold
resistance has not changed. Treat yourself to a nice dab on a clean donut.
●
A little bit of coconut oil makes a great lubricant for the mouthpiece o-rings.
© Copyright DivineTribe ineedhemp.com 2017
–
[email protected] | 707-709-8480
Divine Tribe v3 Ceramic Donut Atomizer Quick Start Guide
