NAME
DATE
DESCRIPTION
REVISION LEVEL
NAME
DATE
DESCRIPTION
REV.
ECN NO.
IN HOUSE ASSEMBLY TEMPLATE
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
300 South Krueger Street
Suring, WI 54174
diversifiedwoodcrafts.com
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
X7000 & X8000 SERIES
METAL ACTIVITY TABLE
ASSEMBLY INSTRUCTIONS
REV C
3 OF 4
NTS
EMK
3/3/14
NOTE:
1.
EMK
3/3/14
CREATED ASSEMBLY INSTRUCTIONS
A
-
STEP 1:
LAY TOP ASSEMBLY ON THE FLOOR WITH THE STEEL FRAME FACING
UP. BE SURE TOP ASSEMBLY IS ON A CLEAN SURFACE TO PREVENT
DAMAGE.
STEP 2:
(IF YOU HAVE A PLAM, CHEMGUARD OR PHENOLIC TOP, CONTINUE WITH
THIS STEP. IF YOU HAVE A EPOXY TOP, SKIP TO STEP 3). INSERT HANGER
BOLT ON ONE OF THE LEGS THROUGH THE CORNER BRACKET AND INSERT
LOCK WASHER AND HEX NUT. TIGHTEN BOLT USING
1
2
" WRENCH OR
1
2
"
SOCKET AND TORQUE WRENCH. FOR PLAM OR CHEMGUARD TOPS, USE
THE SCREWS PROVIDED AND SCREW INTO THE BRACKET ATTACHED TO
LEG TO TABLE TOP (NOT SHOWN). FOR PHENOLIC TOPS, PRE-DRILL HOLES
INTO TOP
3
4
" DEEP WITH A
11
64
" DRILL BIT AND SCREW LEG INTO TOP WITH
SCREWS PROVIDED (NOT SHOWN). MAKE SURE LEG IS SCREWED ON
TIGHT. REPEAT FOR OTHER 3 LEGS.
CLOSE UP OF CORNER LEG ASSEMBLY
INSERT HANGER BOLT
THROUGH HERE WITH
WASHER AND HEX NUT
EMK
6/29/16
UPDATED STEP 2
B
-
EMK
6/30/16
UPDATED TOOLS AND COMPONETS & STEPS 2 & 3
C
-
STEP 3:
FOR AN EPOXY TOP, PLACE SILICONE ADHESIVE TO THE TOP EDGES OF
THE LEGS. INSERT HANGER BOLT ON ONE OF THE LEGS THROUGH THE
CORNER BRACKET AND INSERT LOCK WASHER AND HEX NUT (SEE PICTURE
IN STEP 2). TIGHTEN BOLT USING
1
2
" WRENCH OR
1
2
" SOCKET AND TORQUE
WRENCH. REPEAT FOR THE OTHER 3 LEGS.
STEEL FRAME
FACING UP
CLOSE UP OF CORNER LEG ASSEMBLY FOR
EPOXY TOPS
APPLY SILICONE
ADHESIVE ON
EDGE OF LEGS
TOP
STEEL
FRAME
LEG
K:\DIVERSIFIED\ASSEMBLY INSTRUCTIONS\ACAD\X7000 & X8000 SERIES.dwg, 6/30/2016 12:05:17 PM, DWG To PDF.pc3
