NAME
DATE
DESCRIPTION
REVISION LEVEL
NAME
DATE
DESCRIPTION
EMK
12/4/14
CREATED ASSEMBLY INSTRUCTIONS
REV.
A
ECN NO.
-
IN HOUSE ASSEMBLY TEMPLATE
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
DWN
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
DT-90PL
FOUR-STATION DRAWING TABLE
ASSEMBLY INSTRUCTIONS
REV A
3 OF 3
NTS
EMK
12/4/14
NOTE:
1.
STEP 1:
LAY TOP ASSEMBLY ON FLOOR WITH APRON SIDE FACING UP.
BE SURE TOP ASSEMBLY IS ON A CLEAN SURFACE TO PREVENT
DAMAGE.
STEP 2:
INSERT HANGER BOLT ON ONE OF THE LEGS THROUGH
THE CORNER BRACKET AND INSERT THE LOCK WASHER
AND HEX NUT. TIGHTEN NUT USING A
1
2
" WRENCH OR
1
2
"
SOCKET AND TORQUE WRENCH, TO A MINIMUM OF
12FT LBS BUT NOT TO EXCEED 17FT LBS . REPEAT FOR THE
3 LEGS.
STEP 3:
SLIDE LEG BOOTS ONTO
THE LEGS WITH FLARED
END TOWARD THE BOTTOM
OF LEG. SCREW LEG
LEVELERS INTO T-NUT ON
BOTTOM OF LEG.
STEP 4:
TURN TABLE OVER SO TOP IS UP. LINE UP PENCIL LEDGE ON SIDE OF
ADJUSTABLE TOPS IN DESIRED LOCATION. SCREW PENCIL LEDGE
TO TOP USING SCREWS PROVIDED. HOLES NEED TO BE PREDRILLED
TO PREVENT TOP FROM SPLITTING . SET YOUR TABLE IN PLACE AND
ADJUST THE LEG LEVELERS TO LEVEL THE TABLE. SLIDE LEG BOOTS
DOWN TO THE FLOOR.
APRON SIDE
FACING UP
INSERT HANGER BOLT
THROUGH HERE WITH LOCK
WASHER AND HEX NUT
LEG BOOT
LEG LEVELER
COMPLETE UNIT SHOWN
CLOSE UP OF CORNER LEG ASSEMBLY
CLOSE UP OF LEG BOOT AND LEG
LEVELER ASSEMBLY
PENCIL LEDGES
(TWO ON
OTHER SIDE)
ADJUSTABLE
TOPS
