ASSEMBLY TEMPLATE
NOTE:
1.
REVISION LEVEL
EMK
11/16/16
CREATED DRAWING
REV.
A
-
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
300 South Krueger Street
Suring, WI 54174
diversifiedwoodcrafts.com
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
OCTAGON WORKSTATION
OCTAGON WORKSTATION W/ DRAWERS
ASSEMBLY INSTRUCTIONS
REV A
5 OF 6
NTS
EMK
11/16/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 9:
PUT DRAWERS BACK IN CABINETS. ATTACH RUBBER MOLDING TO BASE OF
WORKSTATION USING CONTACT CEMENT. AFTER MOLDING IS IN PLACE,
SCREW STAINLESS STEEL CORNER BRACKETS ON EACH CORNER OVER BASE
MOLDING WITH THE SCREWS PROVIDED.
STEP 8:
TAKE TOP DRAWER OUT OF REMOVABLE CABINET. ATTACH THE REMAINING
TWO APRONS TO THE REMOVABLE CABINET BY GOING INSIDE THE CABINETS
AND SCREWING THROUGH THE SIDES TO THE APRON. MAKE SURE TOP EDGE
OF APRONS ARE FLUSH WITH TOP EDGE OF CABINETS.
STEP 7:
PUT REMOVABLE CABINET BACK IN PLACE. ATTACH REMOVABLE
CABINET TO THE TWO PERMANENT CABINETS ON THE OUTSIDE WITH
REMAINING SUPPORT BRACKETS AND SCREWS. MAKE SURE BRACKETS
ARE FLUSH WITH THE TOP EDGES OF CABINETS TO AVOID VISIBILITY.
TOP AND PLUMBING FIXTURES REMOVED TO SHOW CLARITY
REMOVABLE
CABINET
SUPPORT
BRACKETS
APRON
ATTACHED FROM INSIDE
OF EACH CABINET
TOP DRAWER REMOVED
TO ALLOW INSTALLATION
OF APRONS
COMPLETE UNIT SHOWN
APPLY RUBBER
MOLDING HERE
K:\DIVERSIFIED\ASSEMBLY INSTRUCTIONS\ACAD\1544K & KF, 1546K & KF, 1644K & KF,
1646K & KF SERIES.dwg, 12/2/2016 11:50:31 AM, DWG To PDF.pc3
