10
Figure 5
Figure 4
Figure 2
Figure 3
Figure 1
F. 4 connection sockets
E. 4 electrodes
B. Hook-and-loop tape
D. Hook and loop tapes
Step 7:
If you want to terminate the application, the stimu-
lation device must be switched off. Then you may
loosen the plug connections (F) and take off the neck
collar.
Step 6:
Now you may connect the Tens/EMS device with the
connection sockets (F). Observe that the stimulation
device (TENS) is switched off when connecting it. After
the connection is established, you may start TENS
application. The impulses flow on either side from one
electrode (E) to the other and vice versa when applied.
Step 5
:
Now put the adjusted neck collar onto the neck and
close the hook and loop tape (B). The electrodes must
rest against the neck.
Step 4:
If the neck collar is set correctly, you need to moisten
the 4 electrodes of the neck collar slightly with water
(see figure 4). It is best to use a moistened cloth for
this.
Step 3:
Then place the 4 electrodes of the neck collar so that
they are placed on the left and right according to
figure 3. This way, the current from one electrode can
reach the other electrode through the nerves.
Step 2:
To adjust the distance between the right and the
left electrodes, move the tow hook and loop tapes
inward or outward. Pushing the electrodes inward
reduces the electrode distance. Pushing the electrodes
outwards increases the electrode distance.
Step 1:
First set the electrodes to your size for application.
Open the electrode collar as in figure 1. Pushing up
and down sets the electrode height. Then place the
top part of the electrode collar onto the neck collar as
in figure 1.
C. Electrode
collar
Application with a stimulation device (TENS)
5.0 Setting, application and use of the neck collar
APPLICATION
GB
PJN091_GA-GB_HHD_TNM275_ TENS Nacken_31.07.12
Dienstag, 31. Juli 2012 20:40:01
